How to Upgrade SDRAM on Your Late 2013 i5 Imac

Upgrading the memory (SDRAM) of your late 2013 i5 imac is not a straightforward process and requires some technical expertise. Before you start, make sure you have backed up all your important files and data as this upgrade will erase all information on the computer.

The first step in upgrading the SDRAM is to locate the memory modules. They are usually located on the logic board of the imac. You'll need to remove the RAM cover to access them. The RAM cover is held by two screws, which you can unscrew using a screwdriver. Once the cover is removed, you'll see the memory modules.

The late 2013 i5 imac has a maximum capacity of 16 GB of SDRAM, and it comes with 8 GB of RAM installed. To upgrade, you will need to purchase additional memory modules that are compatible with your imac's specifications.

Once you have purchased the new memory modules, disconnect the power cord from the back of the imac and unplug any other cables connected to the computer. Then, flip the imac over and locate the screws on the bottom of the case. Remove these screws using a screwdriver, and then lift off the bottom cover.

Next, locate the logic board and the memory modules. You'll see that they are held by clips and latches. Carefully remove the old memory modules from their slots and replace them with the new ones. Make sure they are securely seated in their slots.

Reassemble the imac by replacing the bottom cover and reconnecting any cables you disconnected earlier. Finally, turn on the computer and check to see if the upgrade was successful. If everything went smoothly, your late 2013 i5 imac should now have a total of 16 GB of SDRAM installed.

In conclusion, upgrading the SDRAM on your late 2013 i5 imac requires some technical expertise and can be a bit complicated. However, with the right guidance and the correct components, it is possible to upgrade the memory of your computer.

Upgrade sdram on i5 late 2013 imac